RockBoard RBO POWER ACE MASTER 30 cm Napájecí kabel
The RockBoard Power Ace Master is a 30 cm IEC linking cable with an integrated ON/OFF switch that turns an entire pedalboard or rack setup on and off with a single click. It bridges a standard IEC power cord to a device's IEC inlet, so musicians no longer need to crawl behind a rack or under a board to unplug gear after a session. Rated for up to 6 A at 250 V AC (12 A at 125 V AC), it handles typical pedalboard power supplies, rack units and studio equipment without strain.
- Length: 30 cm — short jumper that keeps wiring tidy behind a board or rack.
- Connectors: IEC Female to IEC Male — fits between any standard IEC power cord and IEC inlet.
- Switch rating: 6 A at 250 V AC / 12 A at 125 V AC — covers the draw of common pedalboard power supplies.
- Weight: 90 g — light enough not to stress the IEC socket on the powered device.
Master Switch for Pedalboards and Racks
The RockBoard Power Ace Master is a 30 cm IEC adapter cable with a built-in ON/OFF switch that powers an entire pedalboard or rack with one click. Instead of unplugging the mains lead after every session, the user flips the switch to cut power to everything downstream. Rated for up to 6 A at 250 V AC (12 A at 125 V AC), it handles typical pedalboard power supplies, rack gear and studio equipment without strain.
Why It Helps
The IEC Female to IEC Male jumper sits between any standard mains cable and the device's IEC inlet, so installation takes seconds. At roughly 90 g, the cable adds almost no strain on the rear IEC socket. The integrated switch removes the need to reach behind a rack or under a board — a small accessory that solves a daily annoyance for gigging and studio players alike.
Přepínač
Ano
Barva
Mikrofonní vstup
Ne
Konektor typu A
IEC Female
Konektor typu B
IEC Male
Napájení
Napájecí kabel
Délka
30 cm
Země původu
Čína
Dokumenty
Informace o výrobci
Bezpečnostní pokyny
Příslušné bezpečnostní pokyny k výrobku nalezneš v návodu k použití.
